Need to paste glass of the car can unexpectedly arise. Situations in which glasses burst or break on the road arises much, and there is not always opportunity to address to auto repair shop. Try to paste glass. But it is necessary to do it extremely accurately.
It is required to you
- New glass for the car
- Molding if you paste windshield
- Sliding support
- The activator — it is applied on the remained old sealant
- Sealant
- Pneumogun
- Knife
- Soil under sealant
- The degreasing structure
- Adhesive tape
- Marker
- Cotton tampon on stick
Instruction
1. Cut off old glass. Remove excess sealant. Prepare the place for new glass.
2. Put on molding if it is necessary. Try on glass. If on your car there are no special emphasis and guides, mark with marker those places on glass and on body which have to coincide. Put glass on sliding support outer side down.
3. Wipe places of insert with the degreasing structure.
4. Apply soil on body. It becomes cotton tampon. Soil is applied with wide strip. Places where there was old sealant, do not ground. Apply soil also on glass in those places where it will contact to sealant. Places where there was old soil, process the activator.
5. Warm up sealant a little and cut off cylinder tip if it is not cut off. Insert cylinder into pneumogun. Apply sealant with equal strip on body. Apply glass so that tags which you have put were combined. Accurately smooth glass, smoothly putting it in the necessary position. Record glass adhesive tape.
6. Leave the machine alone until sealant hardens.