The modern design ideas more often include availability of mirrors at registration of any rooms. Cover with mirror cloths not only columns and wall panels, but also furniture doors, including sliding wardrobes. One of the most widespread ways of installation of mirrors is their mounting by means of glue.
It is required to you
- - mirror cloth;
- - glass-cutter;
- - needle;
- - hair dryer;
- - water;
- - chalk;
- - glue-sealant;
- - frothed polyurethane ribbon.
Instruction
1. Pick up mirror of such thickness that it did not become obstacle to the movement of doors in sliding wardrobe grooves. If the mirror cloth acquired by you has no processed edge, or its form and area are more than the area, taken away under mirror on door, make its cutting. For this purpose, first of all, take measurements of cabinet door.
2. Accurately put mirror on plain surface. Amalgam at the same time has to be from above. Transfer the sizes to cloth. On shear line wet amalgam solution of vinegar or normal water. Attach the rule and carry out along its edge by chalk. Then take needle and precisely on shear line cut through amalgam.
3. Invert mirror cloth and the glass-cutter draw the line symmetric to the shear line drawn on amalgam. Knock with metal part of the glass-cutter on the line. When the chip becomes noticeable, break off surplus of glass. Dry amalgam the hair dryer.
4. Dismantle and place cabinet door so that it has accepted strictly horizontal position. Remove dust and any pollution from surface. As rags use only those materials which do not leave thread and fiber. If it was necessary to apply pure solvents to cleaning of surface of pollution, surely let's them evaporate completely before putting adhesive substances.
5. Use for mounting of mirror the reliable, not destroying amalgam, polyurethane glue sealant and bilateral tape on polyethylene frothed basis. At first put tape, having it so that at installation of door into place it held vertical position. Evenly distribute on tape strip surface, each of which has to be not less than 10 cm in length. After drawing press tape to surface, without removing at the same time protective soy.
6. Also you apply glue-sealant with vertical strips which quantity depends on thickness and the area of mirror cloth. Diameter of strip which is regulated by cutting of plastic tip of the cartridge has to be about 6 mm. You put strips not further 10 cm from edges of mirror and 5 cm are not farther from the pasted tape.
7. Start sticker of mirror cloth. Remove from applied on tape cabinet door protective layer. Put mirror on door and press for uniform distribution of adhesive and achievement of reliable contact of cloth with tape surface.
8. Leave the pasted mirror in horizontal position for 24 hours before full hardening of sealant. Air temperature at the same time has to be not lower than 20 degrees.