If has so occurred that your car has had accident, and you are forced to bring independently it into original state, it is necessary to remember some difficulties and features of restoration of the machine. One of sore subjects of motorists is gluing, or rather mounting of molding on cars. Without having ideas of this procedure, you will long deal with this task.
Instruction
1. Make sure that the molding is alive, healthy, is in working order. You could damage it in the course of dismantling or it could be spoiled during accident. Two metal strips on both sides have to adjoin densely to framework, they should not dangle or disperse from support somewhere. Do not try to paste molding without them: if these strips in bad condition, it falls off all the same. In this case it is worth repairing at first rails or to replace all design with new.
2. Use special adhesive tape for repeated gluing of molding. Address to the nearest hardware store or the automobile center. Explain your situation and consult with the employee of shop what is better to take binding material. Perhaps, will advise you at all and not adhesive tape, and more effective, but also expensive means. In this case the choice for you.
3. Make sure that there are no roughnesses on that place where there is gluing. At detection of dents, but lack of time for their elimination, just close up them. Ways of elimination of similar inconveniences huge set. Construction plasticine perfectly will be suitable for this case, it is fast and available way to remove dent.
4. Eliminate as well cambers if have found those in the course of mounting. Whatever way you have chosen for this purpose, remember that exterior is not basic as this area will be all the same closed by molding after its installation.