Plastic (PVC) windows with qualitative accessories are modern, durable, beautiful and reliable. However, over time sometimes it happens so that the window is closed hardly, from shutters begins to blow, and handles turn already not so smoothly as earlier. Manufacturers of window accessories of Maso have provided possibility of simple independent adjustment of work of window.
It is required to you
- - hexagonal wrench of 4 mm (No. 4);
- - flat-nose pliers;
- - screw-driver.
Instruction
1. If you have noticed that the shutter of window has a little sagged and at the time of closing of window has begun to touch frame, adjust shutter. For elimination of distortion of frame carry out adjustment across, influencing loops.
2. Begin with the top loop. Open loop — you will see opening under hexagon. Insert key into opening and carefully rotate it. Adjustment course no more than ±2 mm. Rotating direction depends on specific problem with window — at rotation of key clockwise the shutter will be attracted to loop and the window bottom opposite to loop will rise.
3. At rotation of hexagon counterclockwise the shutter, on the contrary, will be removed from loop and the window bottom opposite to loop will fall. The lower loop is regulated similarly. At the same time it is not necessary to remove plastic cap from loop, the hexagon enters the special opening located from below the lower loop.
4. For adjustment of shutter of window in vertical plane use the lower loop. Remove plastic cap from loop — under it from above loops you will see adjusting opening under hexagon. Insert key and carefully rotate. At rotation of key clockwise the shutter of window will rise. At anticlockwise rotaition — to fall.
5. For transfer of accessories to summer or winter operating mode adjust special oval pins sideways of window shutter. The standard provision of pins — at an angle 45 °. Accurately grasp pin flat-nose pliers and turn in horizontal position. The shutter clip to frame becomes at the same time stronger (the winter mode). At the provision of pins strictly vertically the clip becomes more weakly (summer operating mode).
6. If at your windows handles began to turn hardly, grease all mobile parts - clowns, loops, clamping mechanisms - oil by means of brush (it is possible Q-tip) and lubricator. If the handle has become loose, then remove plastic plate in its basis and tighten the screw-driver screws.