The house equipped with own hands is twice expensive and we love. Doing repair or updating interior, we arrange it under ourselves, we put heart and soul and with love we make parts. And, if in certain cases it is enough to have only imagination and desire, then in the affairs connected with house communications and electrical wiring it is necessary to have both knowledge and skill. We learn to suspend chandelier.
It is required to you
- Set of tools: combination pliers, set of screw-drivers, insulating tape, the control lamp, the indicator and the perforator if it is required.
Instruction
1. Collect chandelier, as shown in the instruction attached to it. Check hook on which you are going to suspend chandelier, on durability. Then isolate it insulating tape in two layers.
2. Switch off the time cut-out in guard on stair landing. Turn off the light in the room in which you are going to suspend chandelier. The indicator screw-driver check line voltage.
3. Find three ends of wire and remove from them isolation. Do not forget that length of bare wire has to be no more than 3-4 millimeters. Before connecting chandelier, define what of three wires are phase, and "zero", what of them. For this purpose check each wire the indicator screw-driver for availability of phase. If the screw-driver lights up, so wire – phase. Mark with isolation wire "zero". Determine by the same way at wires of chandelier of phase and "zero" correctly to connect the device.
4. Suspend chandelier on hook. Connect phase wires of chandelier to phase wires of wiring on ceiling. Then connect chandelier wire "zero" to the same wire of ceiling wiring.
5. Do not twist among themselves copper and aluminum wires as it will lead to short circuit of wiring and violation of contact. For the correct connection use the special block intended for fastening of wires by screws via the sleeve.
6. Before finally strengthening decorative protective cap of chandelier on ceiling, check quality and correctness of the work. Correctly connected chandelier should not spark and shine dimly. If check has taken place successfully, means it is possible to screw up decorative protective cap of chandelier. Work is ready.