Purchase of the car is capable to present to bring many pleasant impressions, but also you should not forget about emergence of new cares. For example, sooner or later there can be a question as it is correct to paint the car in house conditions. Of course, it is the best of all to trust in professionals, but if such opportunity is not given yet, it is possible to get the corresponding knowledge and to try to carry out this procedure independently.
How it is correct to paint the car in house conditions?
For a start it is worth knowing that there are three types of coloring of a car: full, partial or local. In the first case paint is applied on all body, partially inside and under a cowl, the second option means coloring of any part of a body, and the third way is necessary for masking of chips, dents or scratches.
Painting of the car business difficult, and the most part of success depends on preparation for process. It is also necessary to pick up tools correctly. If you think how it is correct to paint the car with a barrel, then it is necessary to know that this option will be suitable only for correction of small defects. For full painting of the car it will be required to get an airbrush. But about independent coloring think to correct if necessary minor defects more often, and for these purposes of a barrel will be quite enough. The main complexity consists in paint selection, just will be only with new cars for which the code of paint is known. And during the work with older models it is necessary to ask council of professionals or to rely on the accuracy of the color perception, testing several shades. Now it should be taken into account step by step as it is correct to paint the car most by means of a barrel.
- Degrease the processed surface. In the presence of rust smooth out an emery paper, reaching metal.
- Apply acrylic hard putty and let's it dry. At the room temperature it occurs in 20-30 minutes.
- Limit the processed surface to a painting adhesive tape not to damage other sites and start grinding. It is necessary to do it by means of an emery paper, observe requirements for its type – is for work on dry and wet surfaces.
- Remove an adhesive tape and process surfaces, adjacent to the place of repair, an adhesive tape-brightom, then degrease all site and wipe dry. Again use a painting adhesive tape for restriction of a zone of coloring.
- Stir up a barrel and spray paint. It will be required to put 2-3 layers, drying time each about 15 minutes, the last layer should be dried slightly longer – minutes 20. Every time try to come slightly for edges of the first layer (but not further borders of the prepared surface) that the spot merged with an old layer.
- Further putting varnish follows from aerosol package. Also several layers will be required. For degradation of border use special solvent which is applied in 15 seconds after putting varnish.
- After drying of all layers it is required to polish a surface to make even borders of the svezheokrashenny site.
At full coloring the stages remain the same, only at first it is required to wash all car, and it is necessary to close all surfaces which do not need coloring.