The clearance, or road gleam is a distance between a paving and the lower part of the car. Clearance size directly affects passability of the car, a possibility of the movement on off road terrain and overcoming deep holes.
Ways how to increase clearance of the car the hands, exists a little.
Councils how to increase clearance of the car the hands
- The first way will allow to increase a road gleam in several millimeters, without breaking a design of a running gear of a car. For this purpose it is necessary to replace rims and tires of a factory configuration with components of wider diameter that will allow to raise bottom height. In replacement of wheel accessories there are certain negative points: fuel consumption can significantly increase, indications of a speedometer can be not reliable, at turns the surface of a tire will touch a wheel arch and it will lower tire service life.
- The following method assumes installation of overlays for a shock-absorber spring. They are made of plastic, plastic or aluminum that gives a difference of their service life. The highest rate of wear resistance at aluminum slips, upon their purchase you remember that they are both front, and back.
- One more modification on slips is use of mezhvitkovy devices, they invest directly in a spring. This way of increase in clearance has also side effects: the controllability and safety of driving, emergence of vibration can worsen. Along with shortcomings there are also good points: the high term of operation, there will be no flash of a back part of the car at full load.
- It is possible to increase clearance of the car replacement of springs of the shock-absorber with springs with a large number of rounds. Such way of modernization has a high resource of wear and allows not to sink to the car at full load. There is also a reverse of the medal: work of a pendant will change, the rigidity, vibration of a body and running gear will appear.
- The last way which it would be desirable to discuss is a full replacement of a system with a pneumatic pendant with all that it implies with details. For such upgrade it is necessary to spend for acquisition of a set of lobbies and back pneumatic pillows, a receiver, the compressor, sensor of pressure of air and the onboard control panel fairly. The way is quite expensive, both in installation, and in further service, but it is very convenient in use. However, only the masters who are well understanding cars can realize this way the hands.