Finishing putty will allow to increase quality of the subsequent decorative finishing and will allow to create indoors favorable climate that is caused by ecologically harmless properties of the plaster which is its part.
It is required to you
- - capacity for mixing of mortar
- - water
- - electric drill
- - nozzle mixer
- - palettes
- - primer
- - bar for grinding
Instruction
1. Prepare surface of walls for putting finishing hard putty. Take grinding bar, fill in it grid and process all walls and corners. Then ground surfaces. You apply priming solution by means of brush or the roller. Let's walls dry out well.
2. Prepare putty. Being guided by the instruction of the producer, pour water in capacity. Add mix. Establish nozzle mixer on electric drill and prepare spackling solution. Weight has to turn out elastic. That the quality of covering has not worsened, watch consistence of solution. Mix should not be so liquid to flow down from the palette, but also not to be very dense as with such it is very difficult to work.
3. Palettes for work have to be made of stainless steel. Take the wide palette in the right hand. Use it for drawing and extension of solution on surfaces and also removals surplus. In the left hand – narrower tool, no more than 100 mm wide. Also as the main palette it is convenient to use the Swedish finish from 500 to 600 mm wide. Its performance and quality of the put layer are much higher, than at the palette.
4. Apply putty on the main tool by means of the narrow palette. Begin to cover wall with thin layer of solution from any top corner. When drawing layer from right to left have upper part of the palette more to the left in relation to lower, when drawing from left to right – more to the right.
5. Smooth the formed flows the palette. To optimum hold it with inclination of 45 - 60 degrees to wall surface. Change of size of corner will lead to change of thickness of the put layer. For puttying of the corners formed by ceiling and walls use the angular palette of special design.
6. After hard putty is applied on walls, leave it to dry. Then grind surface zatiry, having established in it grid with roughness of 120 units. Process corners by means of average on roughness of abrasive sponge. After the next putting primer it is possible to start pokleyka of wall-paper or painting.