The garage is room which serves for storage, the parking, gas station and also repair work in relation to cars, motorcycles and other vehicles. Garages are different: metal, brick, block, wooden. The best garage of course wooden that walls and floors were from boards, well, as a last resort, from logs. In such garage it is always dry, the car is exposed to corrosion a little.
It is required to you
- For construction of wooden garage it will be required to you:
- - bar of 5 by 15 cm;
- - eaves board 30 mm thick;
- - slate;
- - self-tapping screws of the different sizes;
- - screw driver;
- - timber dogs;
- - cement;
- - sand;
- - small crushed stone;
- - construction level.
Instruction
1. Dig out small ditch, 15 cm in depth, with sizes of 360 cm by 610 cm sand its bottom 3 cm thick. At the edges make timbering on height of 10 cm that then the concrete site was above ground level. Outline in ditch for reinforcing of pipe, unnecessary armature, the metal gauze. Now prepare the concrete solution consisting of 1 part of cement, 3 parts of sand and 2 parts of crushed stone. Fill in with it ditch, carefully leveling it on level. After drying lay all surface roofing material.
2. Mark the sizes of 350 cm by 600 cm on the received site. Now begin to build framework from bar for walls of garage, not less than 250 cm high. Ahead leave the place for gate width and 250 cm high. Collect "lamp" (framework) by means of self-tapping screws, beginning from below, and carefully impregnate the lower bar with anti-septic tank. At once do gable roof, height in the fad of 150 cm do not forget to make ceiling logs. After assembly impregnate all bars with anti-septic tank and fire-prevention structure. Also strengthen all corners from within, having hammered timber dogs.
3. Now beat boards, beginning from below, accurately adjusting, them to each other. Take away boards back wall, having made in it normal outer door. Then side with small narrow window on the one hand. Hammer the front wall costing 50 cm from pieces. Make ceiling, I put boards on large self-tapping screws directly from below to bars. Start mounting of gate. For this purpose also collect framework of gate from bar, putting it flatwise. The most important at gate is the strut from bar going from corner on corner from bottom corner to top. Beat to gate large loops from thick sheet steel, not less than a meter long. Hang gate. Roof slate. Here yours garages is ready. For bigger reliability and safety it is desirable to upholster such garage with galvanized roofing iron, as a last resort, flat slate. The interior finish is already business of your imagination, but do not forget about functionality.