The table-top is capable to turn kitchen from just good - into amazing. It can be made of various materials. It is possible to establish table-top in kitchen independently.
- - tape measure;
- - pencil;
- - hacksaw or sawing machine;
- - tape;
- - circular saw;
- - file;
- - fastenings;
- - emery paper;
- - oil for wood.
1. For a start place table-top on floor cabinets. Leave small gap at back and side wall. If you make installation in kitchen of G-type, then densely connect 2 sections among themselves. It is not recommended to carry out T-joint. After that measure table-top from one end of floor cabinet. At the same time you remember about the place for the laid on panel and ledge in 2 cm.
2. By means of pencil make mark. If you use hacksaw, then mark have to be on face side of table-top. If for work the sawing machine is used, then make marking to bottom side. Further be engaged in sawing. At manual cut use crenulate saw. To avoid chips, it is necessary to paste tape over the place of cut. For the same business you can use also circular saw. Invert table-top the left side down and establish test ruler. Surely process the cut edge file.
3. After installation of table-top note the place for floor cabinet. It is the best of all to do marking on the lower part of table-top. In this case it will be possible to cut without problems opening under washing. Invert washing and apply it to lower face of table-top. Circle it with pencil. Create additional marking, following the instructions attached to washing.
4. The table-top is fixed by means of special fastening. Put it on the prepared place. Leave gaps in 0.5 cm. Then note places for fastening elements. They have to be as equals distances. Drill openings. Well fix table-top.
5. It needs to be prepared for the first application also correctly. The surface is recommended to be ground fine-grained emery paper. Then process table-top the special oil intended for wood.