During repair for dressing of walls more often begin to use imitation of bar. Imitation of bar is same eurolining at which side edges are milled by direct mill at an angle of 35-45 degrees from the board plane. The board of imitation of bar, unlike lining, is mounted in the horizontal plane. Quickly and qualitatively to fix imitation of bar absolutely simply.
It is required to you
- - wooden mounting bar 20×40;
- - dowel "fast mounting" 6×60;
- - hammer drill;
- - drill on tree with a diameter of 6 mm;
- - pobeditovy drill for drill with a diameter of 6 mm;
- - drill with a diameter of 3 mm;
- - screws 3×35;
- - wood saw.
Instruction
1. Fix on wall in vertical position by means of dowels "fast mounting" wooden mounting bar. For this purpose at first drill openings in mounting bar drill with a diameter of 6 mm. Openings you drill at distance 600 mm from each other. Apply level to wall. Through the drilled openings punch the hammer drill with pobeditovy drill of opening in wall on depth of 70 mm from the external plane of mounting bar.
2. Punch one opening in wall approximately in the middle of mounting bar. Attach "fast mounting" mounting bar in this place to wall. Level level down. Fix it completely. In the same way fix other levels. Distance between them make equal 400 – 600 mm across.
3. Begin mounting of board of imitation of bar with extreme lower point of wall. Put horizontally board groove up. Opposite to mounting bars drill in it on one opening drill with a diameter of 3 mm. Openings you drill in internal ledge of groove at an angle 25 – 30 degrees from the horizon with inclination towards board so what the twisted screw pressed board from top to down. These openings will prevent splitting of board during their fastening.
4. Press board to mounting bars and fasten screws 3×35 mm. Extreme lower board of imitation of bar you fix as from upper part (in groove), and from the lower part (at thorn). The lower screws will be closed by plinth later.
5. Insert groove of the following board into thorn of previous. Drill opening of 3 mm in internal ledge of groove. Attach board to mounting bar one screw of 3×35 mm. Drill other openings in board. Attach it screws to mounting bar completely. Thus sew up all wall.
6. Pay attention! If the board sheathes all walls of the room or room, mounting of board is made horizontal "rings", sheathing board for once all horizontal row on all walls of the room around. In that case joining of ranks on corners of the room will be ideal.