The modern market of construction and finishing materials is incredibly rich: it offers the huge range of various products. It is noticed that today wall panels are in special demand. They give to room interior complete look. At the same time, the increased interest in this finishing material can be explained also with the fact that mounting of wall panels does not demand special knowledge: will be able to paste them everyone.
It is required to you
- - heater;
- - wall panels;
- - bucket;
- - brush;
- - water;
- - palette;
- - primer;
- - plumb;
- - drill with drills;
- - screw driver;
- - hacksaw;
- - wood saw;
- - square;
- - pencil;
- - screws;
- - hammer;
- - tape measure;
- - rails;
- - heater;
- - aluminum adhesive tape;
- - special glue.
Instruction
1. Properly warm up the room on which walls wall panels will be pasted. Minimum temperature of indoor air – 10 degrees above zero.
2. Unpack wall panels and leave them for several days in the heated room (you remember: temperature has to be higher than ten degrees).
3. Prepare walls. This operation is carried out in two stages. The first: remove old wall-paper by means of the palette, before having moistened them with water and having allowed to inflate a little. The second: to wall progruntuyta.
4. If walls ideally equal, apply special glue with uniform layer at first on the wall panel (let's it be absorbed), and then on surface of walls. Not later than in half an hour after putting glue apply the wall panel to wall, slightly press and smooth (from top to down and from the center of the panel to its edges). The way of gluing of the following panels (joint in joint or with an overlap) depends on the recommendation of the producer of wall panels which is stated in the instruction attached to goods.
5. If the uneven wall surface also has set of damages and defects before gluing wall panels, establish furring. Remember that furring has to be perpendicular to panels. By means of screws attach furring reechka to wall. The distance between reshetochka has to be 600 millimeters: at too long distance any strong pressing the wall panel can lead to its damage. Apply thin adhesive layer on not foiled party of heater and paste it, and then stick places of compounds of heater with aluminum adhesive tape.
6. After that establish the framing accessories (corners and profiles) and only then paste wall panels.