The grid for climbers will become them not only fine support, but also will help to carry out task of vertical gardening. The design looks beautifully even in the spring, in the winter and in the fall when long-term lianas are removed from support, and one-year already or yet do not grow.
1. It is simple to make rectangular furring. If you have no metal support, then wooden will approach. However, they will serve less, but 4-6 years will stay. Take 2 bars of 50х50 mm 2.5-3 meters high. Put them on the flat platform in parallel each other. The distance between them has to be such what was would like that there was width grid for climbers.
2. Take a little shtaketin. Width of their from 1 to 5 cm. You can arrange them on brusa vertically and horizontally at identical distance, but the furring for plants made of the fence located obliquely will be more beautiful to look.
3. Be defined from what party of brusa will be driven in the earth, so opposite – design top. Beat horizontally fence strip which is longwise equal to grid width. This dostochka has fastened the upper edges of brus. Take another, same width as this fence.
4. Apply it to the upper edge of the left bar. Lower the second edge on the right bar at an angle in 135 degrees. The handle note tilt angle on both ends of shtaketina. Saw off from two parties on these marking. It is template, on it cut other thin dostochka which you will beat from left to right. By means of screws or nails attach the first shtaketina. As it has been told above, its left edge has to appear at the upper edge of the left bar at an angle in 45 degrees. Right lower on diagonal to the right bar. Concerning it this edge of dostochka will lie at an angle in 135 degrees.
5. Parallel to this apply the following rail. That all of them were at identical distance, take small piece of board 10-15 cm wide. Apply it flatwise to one end of the first rail, at this distance fix one party of the second shtaketina. At the same distance attach the second end of this rail.
6. To this measure apply and beat all flat sticks to beads. Distance between them identical, they lie in parallel each other. Now make template for shtaketin which will lie with an overlap on just attached dostochka. Read the second row of rails to beat, on the contrary, from top of the right bar. In relation to it they will have inclination in 45, and rather left – in 135 degrees.
7. Rails do not make out bottom of brus, you will drive it on 50 cm in the earth. Previously paint with mordant with antiseptic properties of brusa and rail from all directions, let's dry. Dress on the lower part of each bar on cellophane bag, strong you obkrutit rope. Put in the prepared holes, fill up them with filling brick, sand, spill water, stamp. The support for climbers is ready.
8. If you have pipes, then take brusa of smaller height. Attach them to iron columns screws and drive in the earth of pipe, and bars will stand on its surface.