Many people dream of own pool table. However there is such pleasure of very decent money. Why to spend means if it is possible to make it independently. It is necessary to stock up with the necessary tool and materials only in advance.
Instruction
1. At production of parts it is necessary to show accuracy. It is not necessary to hurry. Extremely it is not recommended to apply raw material to production of parts. You work can just be gone in vain as when drying, the pool table will be spoiled. Surely several times you make check of all sizes before cutting off, or to fix part. It is possible to change the sizes within 5 millimeters. Maintain all sizes. Otherwise openings of billiard pockets can be just incorrectly located.
2. For a start it is necessary to stock up with bars. They have to be integral, 1005 millimeters long. It is impossible to use the bars consisting of separate pieces. Find the middle at the first and at the second bar and make marks. After that it is necessary to grease with glue surface and to squeeze together the middle of these bars. For the best fastening it is the best of all to take them two nails.
3. After that it is necessary to make openings in the second bar and to pull together them with screws. The ready part can be put aside. It has to dry well. The same way the opposite part becomes. Further it is necessary to saw off the third and fourth bar. They have to be long 535 millimeters. Connect bars by means of glue and screws with the second and first.
4. Now it is possible to pass to check of basic sizes at the ready basis. Also surely pay attention to correctness of form and corners. They have to be accurate 90 °. While there is drying of the basis, do legs. It is also necessary to take care of pads from plywood. It is possible to cut them by means of hacksaw. The abrasive paper well is suitable for cleaning.
5. Legs are greased with glue and are established on screws in corners. After that it is necessary to mark and saw off all 4 corners of the basis under 45 °. Make oshkurivaniye on external boards. Execute marking in bars and cut them hacksaw. Smooth out the place has spent on drink file and varnish sides the bases in 2 layers.
6. Pick up material (plywood, chipboard), with roughnesses on its surface (hillocks, etc.) remove them file and smooth out abrasive paper. Mark contours of table-top (fig. 3) on preparation. Make an incision grooves on all their depth hacksaw and cut down ""superfluous"" chisel. Process surfaces of grooves file.