Jukka loves low humidity and good lighting. It is necessary to water this plant infrequently. It is possible to plant both yucca seeds, and previously implanted shanks. To put and grow up yucca, it is necessary to try to create the conditions, the closest to natural.
It is required to you
- - sand or substrate;
- - activated carbon;
- - easy soil (cespitose and sheet earth, sand).
Instruction
1. Choose the place where you will grow up yucca. Best of all the light and warm room will approach. At the same time direct sunlight is contraindicated to plant, especially hard it is transferred by young yucca. If windows southern, then remove a little plants that direct sunshine did not fall on leaves. If there is opportunity, then grow up plant in the open air in the summer: on the balcony, in garden or kitchen garden. It is desirable that the place has been protected from wind.
2. Be defined how you will plant plant. Ways two: it is possible to put tripping or to multiply plant vegetativno, also this way is called rooting. It can be carried out in several ways. As a rule, flower growers make multiple copies yucca by means of the sprouted shanks, seeds put much less often.
3. To plant yucca seeds, take light soil mix which part the cespitose and sheet earth and also sand, all in the ratio 1:1:1 is. Plant seeds, water the earth and then cover it with glass. Every day glass needs to be wiped, at the same time airing the soil. Approximately in month you will notice that the yucca begins to ascend. Do not forget to water the earth if you see that it dries up.
4. The vegetative way of landing of yucca meets much more often. Implant shanks on top, offsprings or fragments of stalk on which there are "sleeping" pazushny kidneys. Roots at the fragment of plant separated and implanted in sand appear approximately in two months. All this time it is necessary to hold yucca at temperature over 20 degrees, you also watch that the shank stayed in high humidity.
5. To put top shank, cut off it sharp knife. Powder all cuts with the activated carbon pounded in powder. Let's shank couple of hours lie down on air that the cut has dried up. Then land it in damp sand or put in water. A little wood charcoal added to water will prevent development of bacteria. If the lower leaves of shank begin to rot, remove them. Do not forget to change water. When the plant gives roots, plant it to the same soil, as well as seeds (Paragraph 3).
6. That "sleeping" have germinated roots, cut off part of plant and put on damp sand. Kidneys will wake up over time and will flush with roots. When all kidneys sprout, take out trunk from sand, cut on several parts (on one escape on each part), powder cuts with coal and let's them dry up a little. Then land each part. Offsprings implant likewise.