Without water it is impossible to live also day: it is drunk, on it cook food, with it watered... In a word, all and everywhere need water. However there can be it that height of water in the well which is dug out on the site of country house pressure of tap water suddenly has fallen or has decreased. What should I do? The situation is reparable.
- - pump;
- - pipes;
- - pressure sensor;
- - boring mechanism;
- - tank;
- - sensor of height of water.
1. In case water pressure in water supply system has decreased before to undertake something, check whether the pipes pumping water have got littered. If the alleged cause of reduction of water pressure has come true, two further exits follow from this situation – to clean pipes if it is possible, or to replace them new. If suddenly after the work done by you the expected result has not come, means it is necessary to pass to the plan of "B" - to connect the pump to water supply system. In the accompanying summary to the pump the optimum water pressure which has to be in water supply system is specified: it, as a rule, has to be not below indicator 0.2 atmospheres. If in water supply system the water pressure is less, then except the pump establish on it also the pressure sensor (this adaptation artificially will lift water pressure to desirable level). But there is in this mechanism one important part: as soon as you turn on it, at you in water supply system, naturally, water pressure will increase, but here at neighbors in giving it will sharply fall to critically small value therefore wait for "guests".
2. The height of water in well depends on amount of precipitation and season. Quite often during the droughty summer period the well can dry up in general. In this case carry out deepening of well, digging it rings a little smaller (0.7) diameters.
3. If loss of tap water became already so frequent phenomenon that including once again crane, you do not hope for what will be watered, install the tank with the sensor of height of water. From reverse side of capacity, that is that part which crashes into water supply system install the pump which will begin set of water in the tank at turning on of the crane. And if in water supply system there is no water at the moment, the mechanism "will monitor" its emergence and will at once fill with it capacity.