If concrete drops when drawing get on surface which for this purpose has not been intended, then it is not occasion to be upset. There are several ways as it is possible to remove surplus of construction material without prejudice to the basis.
It is required to you
- Vinegar;
- solvent;
- liquid for concrete dissolution;
- special scraper
Instruction
1. As option, try to remove concrete mechanically. That is by means of specialized scraper and brush. However experts assure that way this rather labor-consuming and not always effective. First, during removal of concrete thus you risk to scratch that basis from which you try to clean off finishing material. Secondly, it will be rather difficult to remove up to the end excess covering.
2. Experts recommend to use easier way. For removal of excess concrete use special construction liquid. It is necessary to apply it by means of spray. Accurately distribute emulsion on surplus of concrete then wait for its full dissolution. And then wash away finishing material normal warm water. To achieve the best effect you carry out both of these procedures from special installation under pressure.
3. If suddenly concrete has got on iron covering, for example, on the car standing near the venue of repair work, it can be corrected without problems too. For this purpose try to clean off pollution by means of construction solvent. However, it only under condition if the small surface is mentioned. Well and of course during cleaning strongly it is impossible to rub, otherwise it is possible to scratch surface.
4. It is possible to try to remove concrete from surface by means of vinegar. Only it is necessary to wait when liquid entirely impregnates excess material. After that he easily acts, even by means of simple otkovyrivaniye nails. Besides, if you have fine manicure which is a pity for spoiling, then it is better to use alternative methods.
5. If surplus of concrete is in slots between overlappings, then for their elimination the special installation which works on the basis of spraying of air is necessary. Residues of finishing material it is just blown by powerful stream of compressed air.