Spacious and warm garage – dream of any motorist. In it it is not necessary to warm in the winter breath of hand, growing stiff from touch to ice metal, or to pull the thick jacket doing clumsy. In warm garage it is possible conveniently, with comfort to be located and, without hurrying to be engaged, under pleasant music, in repair or tuning of the favourite car. That such conditions were reality, two conditions – availability of heating services and the warmed garage design are necessary.
It is required to you
- - heater from glass wool (Isover, Ursa);
- - vapor barrier;
- - construction buttons and nails;
- - waterproofing;
- - the glued tape;
- - set of joiner's tools.
Instruction
1. The majority of garages have single-pitch roof. It is the simplest and economic. Its basis is formed by the rafters leaning on the mauerlatny bars put over walls of garage and strongly connected to it anchor bolts. It is the simplest to arrange warming of roof along with its construction. So it turns out much quicker. As rafters use bar which one party (located vertically), is equal to 150 mm. Rafters have at distance from each other of 59-60 cm. This requirement is caused by the fact that the standard width of heater is equal to 61 cm. The small stock on width allows it densely, without gaps to enter space between rafters.
2. Set on rafters from within garage vapor barrier. Carry out fastening by means of construction buttons or brackets. Achieve full tightness of vapor barrier, gluing its joints with the glued tape.
3. Over vapor barrier (from within garage) sheathe rafters wooden lining, fibreboard or any other suitable material. At covering you watch closely to breaking tightness of vapor barrier. In case of breaks stick the torn places with tape.
4. Lay from above between rafters glass wool of ISOVER or Ursa 150 mm thick. If necessary carry out cutting of minvata long sharp knife. When laying try to obtain dense adherence of joints of heater to each other.
5. The edge of thermal insulation (from the top and lower edges of roof) has to coincide with outer vertical surface of walls. It needs to be limited to the board 150 mm wide beaten between rafters. The top edge of board has to be aflush with rafters. Thus, thermal insulation will be framed with tree from all directions.
6. Further works are carried out in the way, normal for the roof device. To rafters it is beaten obresht, material and which way of laying of envy from type of the applied roofing material. Has plunged the obreshet the waterproofing and roofing material keeps within.