The satellite Internet strongly is implemented day after day into our life. It is not strange because its advantages before the others are big. Data transmission rate is 400-450 KB / with, and the cover zone is limited only to coverage of the satellite.
It is required to you
- satellite dish with a diameter from 90 to 120 cm, fastenings to it and also a cable and the converter
Instruction
1. The easiest way of connection is connection through provider which will make necessary setup of the equipment. But if you the supporter of the independent choice, then first of all after installation of a plate took place successfully, select a receiver or the DVB card. Consult with provider, but do not try to be absurdly economical. As a result you can will receive
2. the receiver which will overheat in five minutes and to work for you not to turn out. It should be noted that the largest vendor in this area is TecniSat which proved from the most reliable party.
3. For setup of the satellite Internet at first configure the DVB card. It is supposed that you already configured a terrestrial link. The Dialup or GPRS connection is connected according to the standard instruction which you receive from provider. Begin to configure a receiver. For this purpose make installation in the free slot of PCI.
4. To a receiver you will find a disk with the driver in a set. Install it and pay attention to emergence of the corresponding icon in the office control panel on your monitor. Through a context menu (right-click on an icon) select the Setup4PC function. At you the corresponding window should jump out. In the zone Satellite click Add where you will register a name of your satellite in the line Name. Confirm OK.
5. Click Transponder Management. In the upper right corner of the emerged window enter the transponder, speed and polarization. The entered information should be in sheets of characteristics from provider. As the indicator of correctness of setup emergence will serve in the left side of a window of the colored Signal Quality line. Confirm OK. Click Data Services. Here you enter a name of provider. Click Add and select the transponder which settings you entered initially.
6. For completion of setup of the satellite Internet you needed to register the IP address through Network connection and connection is established.