Reproduction of violet happens sheet shanks or division of bush. Can seem to many beginners that it is very difficult to grow up plant from leaf and for this purpose it is necessary to have certain skills and knowledge. Actually, if it is accurate to handle shank and it is correct to make everything, with rooting of violet there should not be problems.
It is required to you
- - leaf of violet;
- - special soil;
- - baking powder;
- - haydite;
- - small pot;
- - knife.
Instruction
1. Choose the most suitable leaf from the second or third row. It is not recommended to take the topmost or lower leaves as they weaker also can not give posterity. Truncate shank leg a little, having made cut knife at an angle of 45 degrees.
2. It is possible to implant sheet shank in two ways: to put it in water or to put at once to the earth. Both methods have the advantages and shortcomings.
3. The first you sposobnapolnit small jar with narrow neck boiled water. For rooting do not use at all crystal ware as shanks in it quickly rot. Place leaf in water on 2 centimeters, at the same time having left it in hover. You watch that "sole" of shank did not rest against bottom. Put capacity with future violet to the warm and lit place, you only watch that on plant direct sunshine did not get.
4. In two or three weeks you will see that your shank had had backs, therefore, time to plant violet in pot has come. Prepare landing mix. As basis take the special soil intended for violets and add to it sphagnum, coarse bank sand, perlite, the crushed marsh moss and vermiculite. The ratio of baking powder and basis has to be 1:1.
5. Accurately take shank, give it slanting position (about 35-50 degrees), straighten backs on the surface of soil and cover them with earth, having created layer no more than 2 centimeters. Humidify the soil by means of the spray and put plant in the place intended for it.
6. Way to vtoroypodgotovta capacity and soil. Make couple of drainage holes in pot and fill small layer of haydite on bottom. Over drainage fill slightly damp and warm soil, having stamped it a little. Make small deepening (about 1.5 cm) in the soil and establish leaf there, without having forgotten it to incline. Accurately powder with the earth and moisten soil, only do not go too far, otherwise the shank will begin to decay.