During repair or construction the situation when it is necessary to make joint of two parts so that it has ideally fitted into room corner is frequent. If at the same time it is necessary to cut off corner in 45º, act with one of the following ways.
It is required to you
- - ruler;
- - pencil, handle, marker;
- - sheet of paper;
- - protractor;
- - miter box;
- - knife, scissors, fret saw and other cutting tools.
Instruction
1. If the surface of material rather extensive also allows to do marks, draw one of shear lines by means of ruler. Then carry out perpendicular to this line, using the square or any subject with smooth edges, for example, the sheet of paper or the book.
2. Ruler note on each side of angle equal pieces, for example, on 10 cm. Measure distance between the received points and halve it. Connect this point to top of right angle. You have received corner in 45º, now cut material on nacherchenny lines by means of scissors, knife, the fret saw or other tools.
3. Note one of shear lines, take protractor and apply to the line. Find on scale mark in 45º and connect this point to the center of protractor. On the planned lines cut material available tools.
4. Cut paper, film, foil or other easily bending material as follows: find or draw right angle (for the sheet of paper it is any of its corners). Bend leaf so that the next parties have coincided. Cut leaf in the area of bend.
5. If you need to cut off corner in 45 degrees several times, for example, at adjustment of plinth, make template. For this purpose take dense cardboard, draw on it square and cut it on diagonal.
6. To cut materials at an angle 45º in large volumes, buy the miter box, this tool can easily be found in any hardware store. Enclose plinth or rail inside as it will be located in space, and knife it, the fret saw or other tool.