How to install the lighting sensor

Installation of the sensor of lighting is demanded now. And it is not surprising, sensors of lighting not only are convenient, but also are practical. It is possible to install the lighting sensor as outside, for example, in the yard of owner-occupied dwelling or at entrance, and inside, for example, in the apartment.

It is required to you

• - screw-driver with the indicator;
• - drill;
• - tester.

Instruction

1. Sort out operation principle of this mechanism: as soon as in its "visibility range" there is movement, it immediately works, closing chain and connecting the lighting equipment connected to it. At the same time, this "intelligent" sensor has three possible settings: illumination level, shutdown interval and also sensitivity. It is possible to set time interval from 5 seconds to 2 minutes (during this period after detection of the last movement the chain will be still closed, so, light will burn). Programming of level of illumination means setup of the sensor for operation in night-time (in other words, to adaptation the threshold illumination on which the sensor has to work is set). As for sensitivity, the sensitivity of the light sensor is adjusted above, the better it works on movements.

2. At installation of the motion sensor in the room pay special attention to room parameters and also the main ways of the movement of people. If, for example, in the room it is better to establish several doors, then the sensor of lighting in corner: in this position it will be able to control at the same time everything that occurs indoors.

3. Connect the sensor to network with phase current, at the same time it is reasonable to make in addition connection of the control switch which will operate parallel to the motion sensor. By means of tester ring out wiring and find wire which is connected to lighting instrument: from it stretch wire to red contact of the sensor. Then take wire on other side of the switch and connect it with brown contact of the sensor. After that take the wire going from lighting instrument (not from the switch), and attach it to the terminal with blue wire of the lighting sensor.

4. After connection of the sensor fix this adaptation on the place chosen in advance and test its work.