Rank their bad noise isolation as the most widespread shortcomings of multifamily residential buildings. Most "defective" in this plan are panel houses where between panels it is badly closed up connecting seams. To eliminate this defect, you can execute independently additional noise isolation of walls of the apartment.
It is required to you
- - like "shumant" sheets of noise isolation;
- - sheets of penapol;
- - gypsum cardboard;
- - guides for gypsum cardboard laying;
- - drill;
- - pobeditovy drill;
- - plastic dowel;
- - self-tapping screws;
- - tape measure;
- - marker;
- - screw driver.
Instruction
1. If you well hear everything that occurs at neighbors, do not hurry to sew up walls of rooms with sound-absorbing materials, for a start disassemble the electric socket in wall which borders on neighbors as very often the opening under the socket becomes through on two apartments. If the socket at you through, just close up it cement solution, and bring wires to laid on design.
2. Buy sheets of noise isolation, gypsum cardboard and penapol at the rate of the total area of walls of the room, consultants in shop taking into account windows of your room and width of door opening will help to calculate quantity.
3. By means of tape measure measure sheets of gypsum cardboard and on the basis of these measurements establish guides for sheets. Then start installation of noise isolation in guides for gypsum cardboard. For improvement of their fastening use plastic dowel which will fix in addition sheets to wall. For this purpose you need to drill five openings in leaf of noise isolation and by means of the screw driver to twirl fastening element in plastic dowel.
4. After that over sheets of noise isolation establish sheets of penapol and press them sheets of gypsum cardboard which record by means of the screw driver and self-tapping screws to guides.
5. At work on noise isolation of the room it is necessary to remember that the area of the room will slightly decrease, it is worth to remember also that the electrical wiring which has been laid in wall needs to be brought to new surfaces, and for this purpose it is desirable to provide installation from rear side of sheets of plastic protective channels under wires.
6. If not to resort to so cardinal measures, then from Soviet period it is known that with noise isolation carpets on walls partly help to resolve issue. Not fashionably, but it is practical. As the option can try to be upholstered walls with soft textile wall-paper or, for example, pith plates.
7. If noise source at you below (the floor below), it is possible to make floor noise isolation, for this purpose it will be required to you: solution of sand-cement mix, mineral basalt wool and perforator.
8. Remove covering from floor to the overlapping basis by means of the perforator. Then lay on sheets of mineral basalt wool and cover them with solution of cement 8-10 cm thick. After solution dries, lay on it tie (if necessary) and floor covering of type of laminate or linoleum.