The microwave oven became the normal household appliance – and the attitude towards her became corresponding. People do not read the instruction, treat the device negligently and do not follow the recommendations of the producer about care for the furnace. Many forget that the microwave oven needs to be wiped carefully after cooking to remove fat raid and other evaporations. And often it does not come to washing of the camera of the furnace at all. As a result in the body the banal short circuit can be formed.
Instruction
1. Define the cause of breakage. Open the camera of the furnace and examine mica laying which is on side of the camera and closes wave guide exit. If you have found out that the integrity of laying is broken and has hot tear traces, then the reason, most likely, in it.
2. Remove pins on which laying fastens, take out it from the microwave oven and accurately clean it. For this purpose you need a little alcohol and soft rag. Clean laying accurately not to damage it even stronger. Clean also that area of the camera where there was laying. If the body has strong damages, coat it. Laying can be repaired, having stuck by means of "Moment" the damaged sites with mica pieces. If damages too serious, it is the best of all to replace laying new. After that put laying into place.
3. If the microwave oven still does not work, means the safety lock has fused. It is simple to replace it too. Remove all cover of the body by means of the cross screw-driver, under it you will see the electric circuit of the device. On payment of the surge filter the network safety lock will be located. Accurately remove old and also accurately put the new safety lock then densely screw body cover.
4. Carefully clean all inside face of the camera and turn on the heating timer for the minimum time. If the furnace works normally, try to heat glass of water. Only after such working off it is possible to warm food in the furnace and to prepare.