With increase in prices for construction materials it is not favorable to put up buildings which walls are exceeded on thickness of one meter economically. Constantly the cost of energy carriers increases. New methods of construction suggest ""to dress"" houses in heat-insulating system. One of solutions of question is external warming of rooms polyfoam.
It is required to you
- - polyfoam (thickness of 50 millimeters);
- - glue;
- - palette;
- - drill;
- - nozzle mixer;
- - fiber glass grid;
- - perforated corners.
Instruction
1. One of the most effective and inexpensive ways of warming of the house is its covering polyfoam. Choose sheets 50 millimeters thick upon purchase. They on quality will replace heat-insulating brick wall with width in two bricks. At installation of such material temperature indoors will increase by five degrees.
2. If walls of the house have defects, chips, at first level them. For this purpose part cement slurry and roughness zashpatlyuyta. Mix cement and sand in the ratio one to three. Apply with the palette the received mix on surface and let's dry out.
3. Take special glue mix and, adding water, part it. For bringing solution to uniform structure use low-resourceful drill and nozzle mixer. Let's it infuse and smear the sheet of polyfoam. The toothed palette distribute glue on all surface. Apply to wall and paste. Miss the mark as well sides that in seams there were no slots. Have the foam plates densely to each other.
4. In corners and in the middle drill the opening perforator for fastening of dowels fungi. In total on leaf to be necessary five fixtures. Drown hats of dowels level with surface. It will reduce the reinforcing layer, and, so will cut consumption of glue mix.
5. After fixing of polyfoam on house walls, create the reinforcing layer. For this purpose apply fiber glass grid and glue. Apply glue mix on surface and the palette smooth grid. In this case there is no blank place left. It is possible to straighten fiber glass on the area and already then to apply glue. It will be quicker.
6. After grid sticker on all corners, slopes of doors and windows put perforated corners and zashpatlyuyta once again surface of walls. Use dense solution of glue. It does not leave flows. Polish the foam area abrasive wheel of small diameter.
7. Ground walls special soil-paint. Further, paint surface or trim with decorative plaster.