Self-bonding is the ideal material intended for decoration of surfaces. It can give them new look without holding recovery procedures. Self-bondings of various textures and thickness meet.
Instruction
1. This material follows to glue without joints, only with an overlap. Quite often self-bonding is used for giving to door cloth of a new type. For this purpose at first it is necessary to remove it and to put on floor. Unroll on it self-bonding. Do all patterns with not removed protective layer. The cut piece surely has to have stock in 30 mm extensively. The fact is that in pasting process you can accidentally warp pattern. In this case it will be necessary to cut off excess pieces only.
2. Spread out pattern to doors and be reluctant on it stakes. Then turn off edge of pattern on yourself and remove protective film. Wrap it down. Paste "beginning" of self-bonding. Surely drag out it on corners. After that rag iron the beginning. Try to glue exactly. Gradually extend protective film and at once smooth material.
3. Wrap self-bonding on faces of door cloth. Begin to do it from one edge. On corners cut it. It is necessary for reduction of number of layers of overlap. If the overlap has turned out wider than cloth thickness, then surely cut it. Extremely it is not recommended to bend it on reverse side of door. Invert door and paste over the second party. Paste over faces of door with one strip.
4. If for work the door which was in satisfactory condition has been chosen, then there will be enough this procedure. It will turn out beautiful and exactly pasted over. If there was formation of bubbles on surface, then puncture them with thin needle and press to the basis. Air has to come out. Most often bubbles appear at haste in pasting. If you glue material from one edge, smoothing with rag and driving air in not pasted over party, then there will be few bubbles. That self-bonding densely nestled, lay soft fabric on it and iron the iron.