Gradual transition to accounting of the consumed energy by means of counters leads to the fact that many owners of apartments and houses seek to warm the dwellings to cut down costs on heating of the room. Agree, money for warming is much more favorable to spend once, than to pay constantly growing bills for the electric power and heating. In comparison with other parts of structure of the house, most of all heat leaves through walls (40% of heatlosses) therefore warming of walls is represented to the most important. It is possible to warm walls differently, one of inexpensive and effective ways is thermal insulation by means of polyfoam.
- * Fungi for polyfoam attachment;
- * Perforator;
- * Toothed palette;
- * Aluminum corners;
- * Sheet polyfoam of 5 cm in thickness, M25 brands;
- * Glue of "Ceresit" or Kreysel;
- * Mix "Ceresit"
- * Painting grid of 140g/m;
- * Primer
1. Technology of warming of walls by means of polyfoam following: Before warming, level external wall by means of putty, apply primer for the best coupling of materials. It is necessary that plates have not come unstuck from wall together with finish coat.
2. Prepare mix of ST-83 Ceresit according to the enclosed instruction, after the put maturing time, smear mix on the sheet of polyfoam, distributing the toothed palette.
3. Attach the sheet of polyfoam to wall and paste on this mix. However it will be insufficiently. Use the perforator to sheathe house walls. On each sheet of polyfoam use 1 fungus. Establish sheets in chessboard order that on all length of wall the continuous seam was not formed. When all sheets are pasted and sewn, leave wall for three days in order that it has dried out.
4. When the wall dries, it is necessary to reinforce polyfoam painting kapron grid. That to make it, attach it from above over polyfoam nails, lowering grid down, fix it glue "Ceresit" or "Kreysel". Glue should not be too much. To remove excess glue, take the palette and remove glue hillocks.
5. Again take fungi and attach polyfoam to wall already together with grid. For this purpose drill polyfoam and wall and fix by dowels.
6. Level corners by means of aluminum corners, to zashpatlyuyta and drown corner in glue. When all reinforced layer dries, level surface by means of the tserezit, using it as putty.
7. It was necessary only to apply front soil, decorative plaster and to paint wall, or to cover it with vinyl siding.