Lining is ideal and widespread material which is widely used for covering of internal walls of any rooms, rooms, verandahs or balconies. When finishing bath or sauna use of the lining made of deciduous breeds of trees – oak, linden, alder is reasonable, - they do not change and serve quite long time in the conditions of the increased humidity. Wooden lining perfectly looks also outside of the building.
Instruction
1. For a start it is necessary to be defined by what machine to use. The milling or jointing machine has to be big and powerful. Machines with power less than one kilowatt will not approach.
2. Take eaves board dry if there is no dry, take crude, but then it has to be very clean, without blue and dry up it independently.
3. Pick up average length piece of eaves board (20 mm x 100 mm). Further it is necessary to determine lining width. If wide lining is necessary, then from one board one lining will turn out. If narrow lining is necessary, then do two linings of one board. It is the most convenient to use for lining narrow boards, 7-10 cm wide.
4. On the chosen board mark off straight line on which it is necessary to cut off its side. Then saw off noted party on the drawn line. For this purpose, rest trunk against the end of board at the level of belt and carefully push board, directly on saw trunk forward, but not hands. That easier it was possible to saw off board, the saw circle to the machine diameter is necessary more. You watch that the board did not clamp circle.
5. Now it is necessary to recustomize the machine. Establish ruler on necessary width and saw off the second sidewall of eaves board.
6. Again recustomize the machine, now for whizzing (planing). It is necessary to Prostrugat only one party.
7. After that, it is necessary to make in board grooves (deepenings sideways in lining). For this purpose the mill or small saw circle is required. Establish ruler to determine the necessary depth of groove. Grooves need to be made from two parties of board. You watch that the planed party the board concerned ruler - so grooves will turn out more exactly and will be identical from two parties. At the same time, it is absolutely optional that grooves were located strictly in the middle. It is possible to make them slightly higher to the surface of lining.